Axess Ready CM-1115-RT-AR Guía de instalación descargar pdf (Pagina 7)

CM-1115(20)-RT-AR User Manual

Page 6

III. LED Indicators

IV. Remote Connections

AXESS ON

The Axess Ready system is On. The AR system must be on

to enable hard-wired remote control connections.

POWER

The RT system is On and the line voltage is within bounds.

OVER/UNDER VOLTAGE

PROTECTION

The line voltage is above 145V or below 90V and the outlets

are Off.

REMOTE

A hard-wired remote control signal is active and the outlets

are On.

SELF-TEST

The internal surge protection circuitry is fully functional.

Remote control connections are wired to the green 7-pin plug-in Phoenix terminal block on the

front of the unit next to the power cord. The terminal block is shipped with a jumper wire

between pins 1 & 2 so that the unit can be used without a remote control connection. If you will

be using remote control you will first need to remove this jumper wire. You can unplug the

terminal block to make connections and after you have made the connections to the terminal

block, plug it back into the connector on the rear of the unit. Never solder (tin) wires before

inserting into a terminal block – solder cold flows and you will eventually have loose

connections!

The connections are shown below:

1 2 3 4 5 6 7

Pin 1 – Contact Closure

Pin 2 – Contact Closure / Applied Voltage +

Pin 3 – Applied Voltage -

Pin 4 – Remote LED +

Pin 5 – Remote LED -

Pin 6 – Aux Relay Contact

Pin 7 – Aux Relay Contact

Control Inputs

The CM-X-AR products can be controlled by a DC voltage in the range of 5V to 30V, by a contact

closure (such as a relay), by a switch (latching), or by another SurgeX product such as the SEQ.

Switches with gold contacts are recommended for the best long-term reliability.

DC Voltage: The unit will power up when the voltage is present, and power down when

there is no voltage. Connect the positive wire to Pin 2 (Applied Voltage +), and the negative

wire to Pin 3 (Applied Voltage -). The positive and negative connections must be made with

the correct polarity for proper operation.

1 2 3 4 5 6 7 8 9 10 11 12 ... 30 31

Sin comentarios

Axess Ready CM-1115-RT-AR Guía de instalación Pagina 7