Axess Ready CM-1115-RT-AR Guía de instalación descargar pdf (Pagina 19)

CM-1115(20)-RT-AR User Manual

Page 18

VII. Command Line Interface (CLI) Protocol

The Command Line Interface provides complete setup of all functions of the AR. The CLI may be accessed through the Telnet protocol,

and requires a Telnet client program. Some commands of the CLI require administrative rights; these are indicated in the following tables.

Prompts

Prompt

Description

User> Prompts the user to enter the user name (either user or admin).

Password> Prompts the user to enter the password.

SX-iPD> Prompt displayed while logged in.

SX-iPD Reboot Required> Prompt displayed after changes have been made that require a reboot.

This prompt will remain active until the AR has been rebooted.

Control Commands

Command

Description

Admin

Fact Def

get outlet Returns the current status of the outlet. No

set outlet < on | off | cycle > Sets the outlet to the selected state. No

Device Commands

Command

Description

Admin

Fact Def

get location Returns the location ID. Yes New SX-iPD

set location < 20 character max > Sets the location ID. Yes

get cycle Returns the cycle time currently in use in seconds. Yes 10

set cycle < 1-999 > Sets the cycle time in seconds. Yes

get upgrade enable Returns the upgrade enable status. No Disabled

set upgrade enable < yes | no > Enables or disables the ability to upload new

Yes

logout Terminates the telnet session. No

reboot Reboots the AR. Yes

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 30 31

Sin comentarios

Axess Ready CM-1115-RT-AR Guía de instalación Pagina 19